Side-Discharging The Clippings; Installing The Side-Discharge Chute - Toro 20792 Operator's Manual
53cm super recycler
Hide thumbs
Also See for 20792:
- Manual (120 pages) ,
- Operator's manual (21 pages) ,
- Service manual (144 pages)
Table of Contents
Advertisement
Note: To unlock the plug, rotate the lever on the plug
to the right
(Figure
5. Lower the discharge deflector.
Side-Discharging the
Clippings
Use the side discharge for cutting very tall grass.
If the bag is on the machine, remove it and insert the mulch
plug; refer to
Removing the Grass Bag (page 13)
side-discharging the clippings.
Important: Ensure that the rear discharge plug is
locked in place. To lock the plug: Raise the discharge
deflector
(Figure
27), firmly push the plug in until it
snaps into place behind the tabs, and rotate the lever on
the plug to the left
(Figure
1. Discharge deflector
Note: To unlock the plug, rotate the lever on the plug to the
right
(Figure
26).
WARNING
The blade is sharp; contacting the blade can result
in serious personal injury.
Stop the engine and wait for all moving parts to stop
before leaving the operating position.
Installing the Side-Discharge Chute
1. Unlock the side-discharge door
26).
before
26).
Figure 27
2. Rear-discharge plug
(Figure
28).
Figure 28
2. Lift open the side-discharge door
3. Install the side-discharge chute and close the door onto
the chute
(Figure
Removing the Side-Discharge Chute
To remove the side discharge chute, reverse the steps above.
Important: Lock the side-discharge door after you close
it
(Figure
31).
14
(Figure
29).
Figure 29
30).
Figure 30
Figure 31
Advertisement
Table of Contents
