Cleaning Under The Machine - Toro 20792 Operator's Manual
53cm super recycler
Hide thumbs
Also See for 20792:
- Manual (120 pages) ,
- Operator's manual (21 pages) ,
- Service manual (144 pages)
Table of Contents
Advertisement
4. Remove the blade, saving all mounting hardware.
5. Install the new blade and all mounting hardware.
Important: Position the curved ends of the blade
to point toward the machine housing.
6. Use a torque wrench to tighten the blade bolt to 82
N-m (60 ft-lb).
Important: A bolt torqued to 82 N-m (60 ft-lb) is
very tight. While holding the blade with a block
of wood, put your weight behind the ratchet or
wrench and tighten the bolt securely. This bolt is
very difficult to overtighten.
Cleaning under the Machine
Service Interval: Before each use or daily
WARNING
The machine may dislodge material from under the
machine.
• Wear eye protection.
• Stay in the operating position (behind the
handle).
• Do not allow bystanders in the area.
Note: For best results, clean the machine soon after you
have completed mowing.
1. Lower the machine to its lowest cutting-height setting;
refer to
Adjusting the Cutting Height (page
Figure 41
10).
2. Move the machine onto a flat paved surface.
3. Attach a garden hose that is connected to a water
supply to the washout port
1. Washout port
4. Turn the water on.
5. Start the engine and run it until there are no more
clippings that come out from under the machine.
6. Stop the engine.
7. Shut off the water and disconnect the garden hose
from the machine.
8. Start the engine and run it for a few minutes to dry the
underside of the machine.
19
(Figure
42).
Figure 42
Advertisement
Table of Contents
