4-4-25 Hook Capstan, Belt Pulley Removal
1) Remove the Hook Capstan Œ after realeasing
Hook in the direction arrow as shown in detail
drawing.
2) Remove the Belt Pulley ´.
Note : Take extreme care not to get grease on Belt
Pulley ´ at assembling or reassembling.
´ BELT PULLEY
Œ HOOK CAPSTAN
Fig. 4-38 Belt Pulley Removal
Samsung Electronics
4-4-26 Ass'y Motor Capstan Removal
1) Remove the 3 Screws Œ.
2) Remove the Ass'y Motor Capstan ´.
Assembly :
1) Match the 3 holes of Ass'y Motor Capstan ´ to the
3 holes of Main Base. Be careful not to drop or
knock the Ass'y Motor Capstan ´.
2) Tighten the 3 Screws Œ in the direction of arrow
as shown detail drawing.
Note : After tightening screws, check if there is gap
between the head of screws and the top side of Main
Base. There should have no gap between the head of
screws and the top side of Main Base.
HOOK
After reinstalling, adjusting the tape transport
system again.
Disassembly and Reassembly
Œ 3 SCREWS
Fig. 4-39 Ass'y Motor Capstan Removal
C
A
B
´ ASS'Y MOTOR
CAPSTAN
4-19