Downloading The Emulex Adapter Driver For A Sun Host System; Installing The Emulex Adapter Driver For A Sun Host System - IBM TotalStorage DS6000 Attachment Manual
Host systems attachment guide
Hide thumbs
Also See for TotalStorage DS6000:
- Redbook (578 pages) ,
- Redbooks (406 pages) ,
- Introduction and planning manual (119 pages)
Table of Contents
Advertisement
For the recommended host adapter parameter settings, see Host Bus Adapter FC
Support at http://www-1.ibm.com/servers/storage/disk/ds6000.
Note: The Emulex LP9402DC adapter card is a 3.3 volt card only and requires a
Single- and dual-port, fibre-channel interfaces with an Emulex adapter card support
the following public and private loop modes:
v Target
v Public initiator
v Private initiator
v Target and public initiator
v Target and private initiator
1. Record the IEEE number that is printed on the card. You can use the IEEE
2. Refer to the installation instructions provided by your host adapter vendor for
Downloading the Emulex adapter driver for a Sun host system
This section provides instructions to download the current Emulex fibre-channel
adapter driver.
1. Restart your host system.
2. Go to http://www.ibm.com/servers/storage/disk/ds6000/interop.html.
3. Click Interoperability matrix.
4. Click DS6000 interoperability matrix.
5. Find the section for the current version of the driver and firmware that you want.
6. Go to http://www.emulex.com.
7. Click Driver, downloads, and documentation from the left navigation pane.
8. Select IBM from the drop down vendor list.
9. Click the link for the adapter that corresponds to the firmware, driver, and
Installing the Emulex adapter driver for a Sun host system
This section provides instructions to install the Emulex fibre-channel adapter driver.
1. Go to www.emulex.com.
2. From the left navigation pane, click Drivers, Software, and Manuals.
3. Click IBM.
4. Determine the driver you want, and click the link for the adapter driver.
5. Determine the operating system for the driver that you want to download and
3.3 volt PCI slot.
number to determine the WWPN.
their specific installation instructions. See http://www.emulex.com for the latest
documentation.
Click OEM software and documentation.
documentation that you need to install and download the adapter driver.
click Version x-x.xxxx, where x-x.xxxx is the version number for the adapter
driver.
Note: If you are installing the fibre-channel adapter for the first time, you must
specify the correct topology. You must also select the appropriate device
mapping driver.
Chapter 18. Attaching to a Sun host
165
Advertisement
Table of Contents
