Enabling The Radio Interfaces - Cisco 1240AG Series Quick Start Manual

Hide thumbs Also See for 1240AG Series:

Table of Contents

Note

You can restore the access point to its factory defaults by unplugging

the power jack and plugging it back in while holding the Mode

button down until the Ethernet LED turns amber (approximately 2 to

3 seconds).

Enabling the Radio Interfaces

In Cisco IOS Release 12.3(7)JA, the access point radios are disabled by

default, and there is no default SSID. You must create an SSID and enable the

radios before the access point allows wireless associations from other

devices. These changes to the default configuration improve the security of

newly installed access points. Refer to the "Configuring Security Settings"

section on page 33 for instructions on configuring the SSID.

Follow these steps to enable the radio interfaces:

1. Browse to your access point.

2. When the Summary Status page appears, click Radio0-802.11G. The

2.4-GHz radio status page appears.

3. Choose the Settings tab at the top of the page. The radio settings page

appears.

4. Click Enable in the Enable Radio field.

OL-16714-01

Table of Contents

Show Quick Links

Table of Contents