Resetting To Default Configuration; Using The Mode Button - Cisco 1240AG Series Quick Start Manual

Hide thumbs Also See for 1240AG Series:

Table of Contents

Resetting to Default Configuration

If you forget your password that allows you to configure the access point, you

might need to completely reset the configuration. You can use the MODE

button on the access point to reset the configuration.

Note

These steps reset all configuration settings to factory defaults,

including passwords, WEP keys, the IP address, and the SSID.

Follow these steps to delete the current configuration and return all access

point settings to the factory defaults by using the MODE button:

1. Disconnect power from the access point (the power jack for external

power or the Ethernet cable for in-line power).

2. Press and hold the MODE button while you reconnect power to the

access point.

3. Continue pressing the MODE button until the Ethernet LED turns amber.

(approximately 2 to 3 seconds). Then release the button.

4. After the access point reboots, you must reconfigure it using the web

browser interface, the Telnet interface, or the access point console port.

OL-16714-01

Table of Contents

Show Quick Links

Table of Contents