Sony CDP-M400CS Service Manual page 26
Hide thumbs
Also See for CDP-M400CS:
- Operating instructions manual (36 pages) ,
- Specifications (2 pages) ,
- Dimensions (2 pages)
Table of Contents
Advertisement
CDP-M400CS
Electrical Adjustment
Note:
1. CD Block is basically designed to operate without adjustment.
Therefore, check each item in order given.
2. Use YEDS-18 disc (3-702-101-01) unless otherwise indicated.
3. Use an oscilloscope with more than 10MΩ impedance.
4. Clean the object lens by an applicator with neutral detergent
when the signal level is low than specified value with the
following checks.
S-Curve Check
BD board
TP (FE1)
TP (DVC)
Procedure :
1. Chuck the disc (YEDS-18) beforehand.
2. Connect oscilloscope to test point TP (FE1) on BD board.
3. With the power ON, while pressing the TIME and MEGA
CONTROL buttons, press the 1/u button.
Rotate the DISC/ALBUM/CHARACTER dial, select "BU
Test" and press the dial.
4. Rotate the DISC/ALBUM/CHARACTER dial, and select
"bdt S CURVE". Press the dial "LD AL" is displayed.
5. Check the oscilloscope waveform (S-curve) is symmetrical
between A and B. And confirm peak to peak level within 3±1
Vp-p.
S-curve waveform
6. Pressing the MENU/NO button stops the output of the
waveform (S CURVE). "bdt S CURVE"is displayed.
7. To end this mode, press the ?/1 button.
Note : • Try to measure several times to make sure than the ratio
of A : B or B : A is more than 10 : 7.
• Take sweep time as long as possible and light up the
brightness to obtain best waveform.
Adjustment Location: BD board (See page 28)
26
oscilloscope
symmetry
VOLT/DIV : 1V
TIME/DIV : 400 µ s
A
Within 3 ± 1 Vp-p
B
RF Level Check
BD board
TP (RFAC)
TP (DVC)
Procedure :
1. Connect oscilloscope to test point TP (RFAC) on BD board.
2. Turn Power switch on.
3. Put disc (YEDS-18) in to play the number five track.
4. Confirm that oscilloscope waveform is clear and check RF
signal level is correct or not.
Note : A clear RF signal waveform means that the shape "◊"
can be clearly distinguished at the center of the waveform.
RF signal waveform
Adjustment Location: BD board (See page 28)
oscilloscope
VOLT/DIV : 500mV
TIME/DIV : 1 µ s
+0.25
level : 1.2
Vp-p
–0.20
Advertisement
Table of Contents
