Table of Contents
Advertisement
Product Information MAGIC.SENS -- Product range
9. Installation of the Detector Module
. The packaging of the multisensor detector with C--sensor consists of tearproof
PE--ALU laminated film and must be cut open carefully.
After installation and connection of the base, the detector module is set into the base
and turned to the right until it stops.
The detector module can only be placed in the base in the correct position!
9.1. Locking the Detector Module in the Base
The detector module can be locked in the base (removal protection).
Detector modules are delivered with inactive locking!
The locking is activated by breaking the bars (X) out of the base and pushing them
into the corresponding guides, as shown in the pictures
Bars (X) forwards
the breaking- -out
X
10. Dismounting the Detector Module
Unlocked detector modules are dismounted by turning them to the left and taking
them out of the base.
Locked detector modules are dismounted by sticking a screwdriver into the
unlocking opening (Y) so that the bar is pushed upward; at the same time, turn the
detector module to the left.
Bars (X) installed
but inactive
X
Y
Page 32 of 42
PI -- 34.65d
Locking activated
BDL- -4998121218
A23.en /09.02.2007
ST- -FIR/ PRM1 / deh
Hide quick links:
Advertisement
Table of Contents
