Table of Contents
Advertisement
Remote Control Preparation
Battery Installation
Battery Notes
1. Remove the battery holder.
Take hold of the holder at position B and pull it out by pushing position A in
the direction shown by the arrow.
2. Install the battery on the battery holder.
Set a new battery properly with its (+) side facing up as shown in the figure.
3. Insert the battery holder.
Push the battery holder back into its original position.
Remove and dispose of an old battery immediately.
Battery Information:
¡Battery Type: Panasonic lithium battery (CR2025)
¡Battery Life: Approximately 6 months under normal use (at room temperature)
Caution: Improper use of batteries may cause overheating, an explosion
or ignition, resulting in injury or a fire. Battery leakage may damage the unit.
¡Do not disassemble or short the battery. Do not throw a battery into a fire.
¡Keep batteries away from children to avoid the risk of accidents.
¡Be careful to the disposal rules when you dispose of batteries.
CQ-DRX901U
CD RECEIVER WITH DSP & CHANGER CONTROL
HIGH ENERGY
HIGH ENERGY
Neodymium Magnet
Neodymium Magnet
Neodymium Magnet
Center Speaker
Center Speaker
Center Speaker
SPEAKER
TUNE
-HEQ
-BAL/FAD
OPEN/CLOSE
MUTE
-POSI
-GEQ
VOL
SEL
TRACK
(Back side)
Position A
Point the remote control
unit at the main unit's
sensor (REMOTE).
45Wx4+5
MOSFET
OPEN
TILT
BAND
APM
POWER
SOURCE
P· SET
DISP
REMOTE
DISC
D
CQ-DRX901U
Lithium battery
Position B
Battery holder
E
N
G
L
I
S
H
1
11
Advertisement
Table of Contents
