Table of Contents
Advertisement
Advertisement
Table of Contents
Related Manuals for Mamas & Papas Moto G123
Summary of Contents for Mamas & Papas Moto G123
- Page 1 <15m Moto G123 Car Seat MOCS_0316_0813_V3 © Mamas & Papas Ltd. 2013...
- Page 2 WARNINGS TheSe INSTRucTIONS ARe IMpORTANT. pleASe ReAd • cARefully ANd ReTAIN fOR fuTuRe RefeReNce. • Please read thoroughly before commencing installation as an incorrect installation could be dANGeROuS. • do not use this child seat in Passenger seats equiPPed with air bags. • This child seat can be used with the harness for children of 9 to 18kg in weight (approx. 9 months to 4 years). • This child seat can be used without the harness for children weighing 15 to 36kg in weight (approx. 3 years to 11 years). • This seat can only be installed forward facing using a three-point lap and diagonal seat belt. • Do not use this child seat in the home. It has not been designed for home use and should only be used in your vehicle. • The safest seating position for this child seat is on the rear seat of a vehicle. • Never use the child seat without fastening the child’s harness correctly (group 1, 9-18kg) and never attempt to use without fastening it into the vehicle.
- Page 3 • Luggage and other heavy or sharp objects should be secured in the car. Loose objects are liable to cause injury in the event of an accident. • Periodically inspect the harness for wear, paying particular attention to attachment points, stitching and adjusting devices. • Store this child seat in a safe place when it is not being used. Avoid placing heavy objects on top of it. Do not allow your child seat to come into contact with corrosive substances e.g. battery acid. the tyPe of aPProved seat belt you must have warning: the car seat should not be fitted in a passenger seat of a vehicle that has an air bag fitted. (srs) Diagonal belt Lap belt Your child seat can only be installed forward facing using a three-point lap and diagonal seat belt in the front or rear passenger seat of the vehicle.
- Page 4 PARTS AND FITTINGS Headrest Slot Harness Chest pad Backrest Buckle & crotch pad Armrest Harness adjuster lever Harness adjuster strap Seat Belt Lock Belt Button (headrest height adjustment) guide Belt guide Harness strap Seat belt routing slot Harness connector...
- Page 5 CORRECT SHOULDER STRAP HEIGHT No - Too low No - Too high Yes - Correct CHANGING THE SHOULDER STRAP HEIGHT Firstly, release the strap holding the backrest cover on to gain access to the harness. Slide one of the harness straps off the harness connector (1).
- Page 6 ReMOvING The SAfeTy hARNeSS ShOuldeR STRApS Release the strap at the bottom of the backrest cover to gain access to the harness (1). Slide both the harness straps off the harness connector (2 & 3) at the back of the backrest and pull the webbing through the slots in the seat backrest and fabric cover. ReMOvING The SAfeTy hARNeSS lAp STRApS Turn the webbing retainers on their narrowest end and feed them through the slots in the base of the seat, then through the slots in the fabric cover.
-
Page 7: Tightening The Harness
fastening the safety seat buckle Slot the two metal sections of the buckle connectors together (1). Slot the two buckle connectors into the slot in the top of the buckle until they “click” into place (2). Always check the harness is correctly locked by pulling the shoulder straps upwards (3). To release the harness, press the red button on the buckle downwards. TIGhTeNING The hARNeSS Pull the shoulder straps upwards to remove the slack from the lap sections of the harness (1). Now pull the adjuster strap until the harness is fully tightened (2). The harness should be adjusted as tightly as possible without causing discomfort to your child. Ensure that the lap strap portion of the harness is located as low as possible towards the thighs-not around the tummy. A loose harness can be dangerous. Check the harness adjustment and tighten each time the child is placed in the seat... - Page 8 SLACKENING THE HARNESS The harness is slackened by pressing the lever (under the seat cover) on the front of the seat. Press down on the label marked press (1) as you grip the two shoulder straps with your other hand. Pull the shoulder straps towards you to loosen the harness (2).
- Page 9 Check the webbing of the seat belt has not become twisted or tangled and that the lap belt goes under both armrests, the diagonal belt goes through the belt guide on the side of the headrest (3). The diagonal belt goes over the armrest closest to the car's seat belt buckle.
- Page 10 ADJUSTING THE HEADREST HEIGHT 15-25KG (approx. 3 years to 11 years). (According to the child’s height) The headrest can be adjusted up or down. Put your left (or right) hand on the backrest. Pull the button with your other hand. Move the headrest up or down as required ensuring the position fits your child.
- Page 11 Place the car seat onto the vehicle’s seat. Ensure that the backrest of the seat is pushed firmly against the backrest of the vehicle’s seat (1). Place the child in the child safety seat (2). Fasten the seat belt. Make sure that both the sections of the seat belt webbing go under the armrest closest to the buckle.
- Page 12 IMPORTANT: THE SEAT BELT LOCK MUST BE USED. The seat belt lock can be found inside the cover at the back of the booster cushion. Place the booster cushion on the vehicle’s seat, ensuring it is firmly against the vehicle’s seat and backrest (1). Place the child on the booster cushion (2).
-
Page 13: Care And Maintenance
cARe ANd MAINTeNANce THESE INSTRUCTIoNS ARE IMPoRTANT. PLEASE READ CAREFULLY AND RETAIN FoR FUTURE REFERENCE. backrest cover removal: First release the elastic strap at the bottom of the backrest cover. Slide the cover off. The cover can now be cleaned. headrest, booster cushion cover removal: Slide the cover off. The cover can now be cleaned. washing the covers: The covers should be hand washed using a mild soap and warm water. Do not use chemicals and never attempt to bleach or dye the webbing. Allow to dry naturally. IMpORTANT NOTe: The seat restraint must not be used without the cover. The seat cover should be replaced with one recommended by the manufacturer, because the cover constitutes an integral part of the restraints performance. Do not use the car seat after an impact or accident. Please remove the car seat from the vehicle when it is not used and keep out of reach of your child. Please always fasten the car seat when it is inside the vehicle. Please always read the manual before using it. The manual is located in the pocket at the side of the seat. - Page 14 1. This is a “Universal” child restraint, it is approved to ECE Regulation 44.04 for general use in vehicles and will fit most, but not all vehicle seats. 2. A correct fit is likely if the vehicle manufacturer has declared in the vehicle handbook that the vehicle is capable of accepting a “Universal” child restraint of this group. 3. This child restraint has been declared “Universal: under more stringent conditions than those applied to earlier designs which do not carry this notice. 4. If in any doubt, consult either the child restraint manufacturer or the retailer. eXTReMe hAZARd only suitable if the vehicle is fitted with 3-point static, Do not use in passenger 3-point retractor safety seats equipped with air belts, approved to UN/ECE bags (SRS) Regulation no. 16 or other equivalent standards.
- Page 15 after sales service: If you need assistance, spare parts or you are unhappy with any aspect of the goods please contact Customer Care on: +44 (0)845 268 2000, or e-mail us at: customer.care@mamasandpapas.com. Visit our website at www.mamasandpapas.com for the latest product information.
- Page 16 HD5 0RH, UK mamasandpapas.com mamasandpapas.ca mamaspapas.kr T: +44 (0)845 268 2000 T: 1-800-490-0331 T: 1-800-667-4111 +44 (0)845 268 2000 T: 1300-663-034 1-800-490-0331 1-800-667-4111 /mamasandpapasuk /mamasandpapasusa 1300 663 034 /mamasandpapasmaltaregion /mamasandpapasmagyarorszag @mamasandpapas /user/mamasandpapasglobal mamasandpapasblog.com /mamasandpapas...