Table of Contents
Advertisement
Installing or Swapping a Hard Disk Drive
1. Power off the system and ensure it is disconnected from the AC power
source.
2. Open and remove the front door.
3. Remove the left and right side panel as described earlier in this chapter.
4. Tag and disconnect all interface cables and voltage cables connected to all
drives in the drive bay.
Note:
with five screws: one screw is located on the left side of the
drive bay, two screws are located at the front of the drive
bay, and two additional screws are located at the right side
of the drive bay.
5. Remove the two mounting screws securing the drive bay to the right side of
the chassis. See Figure 4-28, A, and B.
Figure 4-28. Removing the Hard Disk Drive Bay
4-32 Dissasembly and Reassembly
The drive bay is secured to the system chassis
E
A
B
C
D
Advertisement
Table of Contents
Troubleshooting
