Table of Contents
Advertisement
Installing or Swapping a Hard Disk Drive in a Hot-Swap Bay
This procedure describes installing a new hard disk drive or swapping out a
faulty drive from one of the six hot-swap SCSI disk drive bays. The SCSI drives
must use the industry standard 80-pin Single Connector Attachment (SCA)
connector. Each drive must be installed in a drive carrier.
Note:
representative or dealer.
If installing new drives, follow an installation scheme starting with the
!
left-most drive. Fill the bays left-to-right (1 through 6). See Figure 4-19.
Figure 4-19. SCSI Disk Drive Installation Scheme
The hard disk SCSI address assignment is:
!
If an individual SCSI drive fault LED (yellow light) is on steadily, this
!
indicates that the drive has been flagged as faulty by the RAID host
controller (See Figure 4-19,A). Follow the procedure described in this
section to remove the faulty drive and swap in a good one.
4-24 Dissasembly and Reassembly
To order a disk with a carrier, contact the sales
0
1
2
1
2
3
Bay
Device
1
First Hard Disk (Left)
2
Second Hard Disk
3
Third Hard Disk
4
Fourth Hard Disk
5
Fifth Hard Disk
6
Sixth Hard Disk (Right)
A
3
4
5
4
5
6
B
SCSI ID Address
0
1
2
3
4
5
Advertisement
Table of Contents
Troubleshooting
