Installation; Installing The Wall-Mount; Affixing The Operation Panel Sheet; Changing The Roll-Paper Detector Position - Epson TM-U220 Reference Manual
Hide thumbs
Also See for TM-U220:
- User manual (197 pages) ,
- Service manual (102 pages) ,
- Product information manual (7 pages)
Table of Contents
Advertisement
B.1.3 Installation
Before installation, be sure that the printer and all equipment connected to the printer is turned
off. Detach all cables from the body of the printer.
B.1.3.1 Installing the wall-mount
CAUTION:
The weight of the printer is approx. 2.5 kg for the TM-U220 Type B, and approx. 2.3 kg for
the TM-U220 Type D. In order to insure that the wall-mount can properly support the
weight of the printer, please secure it with screws appropriate to the type of wall the
wall-mount is installed on. A screw with 4 mm diameter and length of 12 mm or more is
recommended. The thickness of the wall should be 10 mm or more.
Be sure to fasten the wall-mount securely to the wall with a screw in each of the ten
holes.
Before attaching the wall-mount, make sure enough space
remains around the printer.
Make sure that there is enough space for opening the
printer cover.
Attach the wall-mount to the wall in the position illustrated to
the right (with the area marked A at the top), and fasten
securely with ten screws. These screws are not included;
please use screws appropriate to the type of wall being
used.
B.1.4 Affixing the operation panel sheet
When you mount the printer on the wall, the operation panel on the printer will be upside
down. Therefore, operation panel sheets in the correct direction for wall mounting have been
enclosed.
Align the FEED switch mark on the operation panel sheet with the FEED switch mark on the
printer operation panel and affix the operation panel sheet to the printer.
B.1.5 Changing the roll-paper detector position
Two types of screws are used with the WH-10: 3×6 and 3×10. The longest screw (3×12) will not
be used.
1. Open the roll paper cover.
For a model that does not have a roll-paper near-end detector and does not need a change in
paper width, jump to step 7. For a model that does not have a roll-paper near-end detector
and needs a change in paper width, jump to step 3
B-2 How to Install the Printer on a Wall with the WH-10
84mm
A
48mm
Rev. E
Advertisement
Table of Contents
