Using The Wireless Remote Commander - Sony PXW-X180 Operating Manual
Solid-state memory
camcorder
Hide thumbs
Also See for PXW-X180:
- Operating manual (112 pages) ,
- Manual (100 pages) ,
- Update manual (26 pages)
Table of Contents
Advertisement
Using the Wireless
Remote Commander
Before use
Before you use the supplied Wireless Remote
Commander for the first time, pull out the
insulation sheet from the battery holder.
Insulation sheet
A CR2025 lithium battery is set in the holder at
the factory.
Using the Wireless Remote Commander
For controlling the camcorder from the Wireless
Remote Commander, activate the remote control
function of the camcorder after turning the power
on.
Activating/deactivating the remote control
function can be achieved using the Setup menu.
To activate using the menu
Press the MENU button to set the camcorder to
Menu mode, then set "IR Remote" (page 86) of
the System menu to "On."
Notes
• Aim the Wireless Remote Commander towards the
remote sensor to operate your camcorder.
• Point the remote sensor away from strong light sources
such as direct sunlight or overhead lighting. Otherwise,
the Wireless Remote Commander may not function
properly.
• When you are operating with the Wireless Remote
Commander supplied with your camcorder, your video
device may also operate. In that case, select a
commander mode other than DVD2 for your video
device, or cover the sensor of your video device with
black paper.
Replacing the battery in the Wireless
Remote Commander
Use a commercially available CR2025 lithium
battery. Do not use any battery other than a
CR2025.
1.
While pressing on the tab, inset your
fingernail into the slit to pull out the battery
case.
2.
Place a new battery with the + side facing up.
3.
Insert the battery case back into the Wireless
Remote Commander until it clicks.
Tab
WARNING
• Battery may explode if mistreated.
Do not recharge, disassemble, or dispose of in
fire.
• Batteries shall not be exposed to excessive
heat such as sunshine, fire or the like.
CAUTION
• Danger of explosion if battery is incorrectly
replaced. Replace only with the same or
equivalent type recommended by the
manufacturer.
When you dispose of the battery, you must obey
the law in the relative area or country.
• When the lithium battery becomes weak, the
operating distance of the Wireless Remote
Commander may shorten, or the Wireless
Remote Commander may not function properly.
In this case, replace the battery with a Sony
CR2025 lithium battery. Use of another battery
may present a risk of fire or explosion.
Using the Wireless Remote Commander
21
- Quick Links:
- Recording Format
Hide quick links:
Advertisement
Table of Contents
