Table of Contents
Advertisement
3-3-2. CASSETTE DRIVE GEAR (See Fig. 3-3-3)
1) Refer to section 3-3-1 and remove the cassette mecha-
nism assembly.
2) Remove clamps 1 and 2, then remove the gear holder
3.
3) Remove the clamp 1, then remove the pinion gear 4.
4) Remove the clamp 2, then remove the lockgear 5.
ASSEMBLY NOTES:
1. Put the tray in the EJECT mode position before fitting
any parts.
2. Apply grease (VHJ-0100) to the gear mounting shafts,
all the gear teeth, and the cam part of the drive gear 6.
3. Ensure that the drive gear, the lock gear and the pinion
gear interlock correctly, as shown in Fig. 3-3-2.
4. Make sure the clamps 1 and 2 snap in to the gear
holder 3.
Tray
6 Drive gear
5 Lock gear
(grease the outer rim
of the teeth)
Apply
grease
4 Pinion gear
(grease
1
the outer rim
of the teeth)
Clamp
2
Clamp
3 Gear holder
Fig.3-3-3
3-3-3. DOOR OPENER, UNDER FRAME AND
STAND L (See Fig. 3-3-4)
1) Remove the cassette mechanism assembly, referring to
section 3-1.
2) Remove the two clamps 1 and take out the under
frame 2, pulling it towards you.
3) Press down the tray lock lever 3 and the lid opener
lever 4, and loosen the tray 5, lifting it away from you.
In this state, press the clamp 6 and remove the door
opener lever 7.
4) Remove the two clamps 8 and take out the stand L 9.
Be careful not to exert too much force on the clamps 8,
as this could cause damage.
ASSEMBLY NOTES:
1. Apply grease (VHJ-0100) to the grooves !¡ on the
stand L, the inside of the hole !£ in the drive shaft !™.
and the mounting hole !¢ in the door opener lever of
the stand R.
2. Before fitting the stand L 9, be sure to move the tray
5 back as far as the EJECT mode position. Put the two
pins 0 on the tray 5 into the grooves !¡ on the stand
L. Put the drive shaft !™ into the hole !£.
3. Be suretofasten the two clamps 1 and theclamp 6 on
the stand R, and to fasten the two clamps 8 on the
stand L.
9 Stand L
!¡ Grooves
!£ Hole
0
Pins
1 Clamp
!™ Drive
shaft
6 Clamp
7 Door opener
lever
2 Under frame
5-9
3 Tray
4 Lid opener
lock lever
lever
5 Tray
Stand R
!¢ Hole
1 Clamp
Fig.3-3-4
8
Clamps
Hide quick links:
Advertisement
Table of Contents
