Lenovo x3550 M4 Installation And Service Manual page 225

Table of Contents

Figure 110. RAID adapter battery or flash power module removal

Attention: Make sure that the cable is not pinched and does not cover any

connectors or obstruct any components on the system board.

6. Disconnect the cable from the connector on the battery.

Note: You don't have to disconnect the cable from the flash power module.

7. Lift the battery or flash power module up to remove the it from the holder.

If you are instructed to return the RAID adapter battery or flash power module,

follow all packaging instructions, and use any packaging materials for shipping

that are supplied to you.

Replacing a RAID adapter battery or flash power module

Use this information to replace a RAID adapter battery or flash power module.

About this task

When you install any RAID adapter that comes with batteries or flash power

modules, it is sometimes necessary to install the batteries or flash power modules

in another location in the server to prevent the batteries or flash power modules

from overheating. Depending on your server model, a battery or flash power

module must be installed remotely near the optical drive cage or the backplane.

The 2.5-inch server models support up to two batteries or flash power modules.

To install a RAID adapter battery in the server, complete the following steps:

Chapter 6. Removing and replacing components

Troubleshooting