Removing The Bezel - Lenovo x3550 M4 Installation And Service Manual

Table of Contents

Figure 190. System battery installation

a. Tilt the battery so that you can insert it into the socket on the side opposite

the battery clip.

Figure 191. System battery installation

b. Press the battery down into the socket until it clicks into place. Make sure

that the battery clip holds the battery securely.

c. If you removed a rubber cover from the battery holder, use your fingers to

install the battery cover on top of the battery connector.

7. Reinstall the PCI riser-card assembly 2 (see "Replacing a PCI riser-card

assembly" on page 237), if necessary.

8. Install the cover (see "Replacing the cover" on page 203).

9. Slide the server into the rack.

10. Reconnect the external cables; then, reconnect the power cords and turn on

the peripheral devices and the server.

11. Start the Setup utility and reset the configuration.

v Set the system date and time.

v Set the power-on password.

v Reconfigure the server.

See "Using the Setup utility" on page 102 for details.

Removing the bezel

Use this information to remove the bezel.

Chapter 6. Removing and replacing components