Lenovo x3550 M4 Installation And Service Manual page 308

Table of Contents

Figure 196. T8 Torx screwdriver

Figure 197. Bezel screws installation

10. Turn on the peripheral devices and the server.

Removing the front USB connector assembly

Use this information to remove the front USB connector assembly.

About this task

To remove the front USB connector assembly, complete the following steps:

1. Read the safety information that begins on "Safety" on page vii and

2. Turn off the server and peripheral devices and disconnect the power cords and

3. Remove the hard disk drives and filler panels from the hard disk drive bays

4. Remove the bezel (see "Removing the bezel" on page 287).

System x3550 M4 Type 7914: Installation and Service Guide

6. Reinstall the hard disk drives and drive bay filler panels into the drive bays

(see "Replacing hot-swap hard disk drives" on page 212 or "Replacing

simple-swap hard disk drives" on page 216).

7. Install the cover (see "Replacing the cover" on page 203).

8. Reconnect the power cords and any cables that you removed.

9. Slide the server into the rack.

"Installation guidelines" on page 33.

all external cables, if necessary.

(see "Removing hot-swap hard disk drives" on page 211 or "Removing

simple-swap hard disk drives" on page 215).

Troubleshooting