264-906-000
Tape Test Failed
Explanation: Tape Test Failed. Unrecognized error.
Severity: Error
Serviceable: Yes
Recoverable: No
Automatically notify Support: No
User response: Complete the following steps:
1. Clean the tape drive using the appropriate cleaning
media and install new media.
2. Run the test again.
3. Make sure that the drive firmware is at the latest
level.
4. Rerun the test after upgrading to the latest firmware
level.
5. Make sure that the DSA Diagnostic code is at the
latest level.
6. Run the test again.
7. Check the system firmware level and upgrade if
necessary.
8. Run the test again.
9. If the failure remains, refer to "Troubleshooting by
symptom" in the system "Installation and Service
Guide" for the next corrective action.
Related Links:
IBM Support Website
v
Latest level of DSA
v
Latest level of BMC/IMM
v
264-907-000
Tape Test Failed
Explanation: An error was found in the block address
somewhere.
Severity: Error
Serviceable: Yes
Recoverable: No
Automatically notify Support: No
User response: Complete the following steps:
1. Clean the tape drive using the appropriate cleaning
media and install new media.
Related Links:
IBM Support Website
v
Latest level of DSA
v
Latest level of BMC/IMM
v
264-906-000 • 264-908-000
264-908-000
Tape Test Failed
Explanation: An error was found in getting tape
capacity.
Severity: Error
Serviceable: Yes
Recoverable: No
Automatically notify Support: No
User response: Complete the following steps:
1. Make sure that medium is present.
2. Clean the tape drive using the appropriate cleaning
media and install new media.
Related Links:
v
IBM Support Website
Latest level of DSA
v
Latest level of BMC/IMM
v
Appendix C. DSA diagnostic test results
595