Installing A Usb Embedded Hypervisor Flash Device - Lenovo x3550 M4 Installation And Service Manual

Table of Contents

Figure 61. Fan installation

6. Insert the fan into the fan slot in the fan assembly bracket and press it down

If you have other devices to install or remove, do so now. Otherwise, go to

"Completing the installation" on page 92.

Installing a USB embedded hypervisor flash device

Use this information to install a USB embedded hypervisor flash device.

About this task

To install a USB hypervisor flash device, complete the following steps:

1. Read the safety information that begins on "Safety" on page vii and

2. Turn off the server and peripheral devices and disconnect the power cords.

3. Remove the cover (see "Removing the cover" on page 36).

4. Install the flash device:

System x3550 M4 Type 7914: Installation and Service Guide

until it is seated correctly in the slot and the fan connector is seated correctly in

the connector on the system board.

Note: Make sure that the newly-installed fan aligns horizontally with other

correctly-seated fans for proper installation.

"Installation guidelines" on page 33.