Table of Contents
Advertisement
Quick Links
TM
Service & Troubleshooting
M&S Systems is committed to producing high
quality audio products for the home. If you have
any questions or problems with the speaker
systems or the system is not operating properly,
contact your WaveGuide installer or call M&S
Systems at (800) 366-9422.
2861 Congressman Lane
Dallas, TX 75220
800.877.6631
www.mssystems.com
115986
In-Wall & Ceiling Speakers
Owner's Manual
Part Numbers
WG100C
WG150C
TM
WG100W
WG150W
Advertisement
Table of Contents
Related Manuals for M&S Systems WaveGuide WG100C
Summary of Contents for M&S Systems WaveGuide WG100C
-
Page 1: Part Numbers
Service & Troubleshooting M&S Systems is committed to producing high quality audio products for the home. If you have any questions or problems with the speaker systems or the system is not operating properly, contact your WaveGuide installer or call M&S Systems at (800) 366-9422. -
Page 2: Warranty
Molded in IR lens that allows installation of an infra-red receiver through the speaker baffle Gasket around the baffle to provide an acoustic seal Description Ceiling Speakers (Sold in Pairs) WG100C Frequency Response 50Hz to 20kHz (+/-3db) Maximum Power Rating 100 Watts Impedance Rating 8-Ohms Overall Speaker Dimension 9”... - Page 3 Step After the speaker is mounted, adjustments to the swivel tweeter (small speaker) can be made by either directing the sound visually or by using a musical source to determine the best sound coverage for the listening area. To position the tweeter, press at the outside edge of the tweeter housing (DO NOT PRESS ON THE CONE DIRECTLY).
-
Page 4: Unpacking Your Speakers
Insert the frame in the wall and tighten the tabs with the screws on the front of the baffle. Attach the speaker cable to the speaker by pressing down on the red (+) or black (-) gold-plated push terminals and inserting the speaker... - Page 5 The following is a partial list of ways to protect the speaker: Use an RE-16 speaker cover Use a piece of wood that will cover at least 3 feet on either side of the speaker opening.
- Page 6 3 inches thick in the stud cavity. This insulation should not have a backing or if it does, the backing must be installed facing away from the speaker. The insulation should extend about 2 ft.
- Page 7 Step 11. You are now ready to install the speaker. Remove the paint mask from the baffle. Be careful not to touch the speaker cones and tweeter when removing the paint mask in order to prevent any damage. Attach the...
- Page 8 Twist the ends of the stranded cable so the wires are tight. Step 4. Follow the instructions included with the volume control and amplifier. Step 5. You are now ready to install the speaker. FIGURE 3 Positive (red) Negative (black)
-
Page 9: Speaker Installation
Step 3. Drill a 1-inch hole in the center of the Page 16 Remove the paint mask from the baffle. Be careful not to touch the speaker cones and tweeter when removing the paint mask in order to prevent any damage. Attach the... - Page 10 Reinstall the grille on the speaker. Step 8. Adhere the WaveGuide logo to the grille with the pressure sensitive tape. Repeat the steps for the second speaker. Page 10 h i g h e s t pattern m u s t horizontal +/-3dB.
- Page 11 The rings have “flaps” that are nailed/screwed/stapled onto the studs. See figure 8. Once the wall board is installed, the opening is cut out and the speaker frame is inserted into the mounting ring. When installing ring, note that...
- Page 12 FIGURE 9 i n s t a l l a t i o n . Run the other end of the speaker cable to the audio source. NOTE: Make a drawing of each speaker location.