Fuser Roller; Scanning Area - Canon FAX-L160 Reference Manual
Hide thumbs
Also See for FAX-L160:
- Reference manual (187 pages) ,
- Starter manual (31 pages) ,
- Service manual (128 pages)
Table of Contents
Advertisement
■
Fuser Roller
If black streaks appear on printouts, the fuser roller in the main unit
may be dirty. Should this occur, clean the fuser roller according to the
following procedure. The roller should also be cleaned each time the
toner cartridge is replaced. Load a sheet of blank A4 paper into the paper
feeder and start cleaning.
Cleaning the roller takes approximately 180 seconds.
1.
Press [Menu].
2.
Press [
] or [
CLEANING>, then press [OK].
3.
Make sure that a sheet of blank A4 paper is in the
paper feeder.
4.
Press [
] or [
CLEANING>, then press [OK].
Use standard paper as the cleaning paper.
Throw away the cleaning paper after use.
7-6
] to select <ADJUST./
] to select <FIX.UNIT
■
Scanning Area
Keep the scanning area clean to avoid dirty copies or faxes to be sent.
If your documents have black streaks or appear dirty after copying
them using the ADF, this may be caused by pencil lead rubbing off the
documents and onto the roller. Clean the ADF scanning area and roller.
1.
Disconnect the power cord from the machine.
2.
Lift the paper stack cover and pull it out
completely.
Make sure the back end of the cover does not catch the front paper guide.
- Quick Links:
- Fax Mode
Hide quick links:
Advertisement
Table of Contents
