IBM 6C1 Service Manual page 107
Pseries 610
Hide thumbs
Also See for 6C1:
- Technical overview and introduction (40 pages) ,
- Technical overview and introduction (42 pages) ,
- Installation manual (144 pages)
Table of Contents
Advertisement
Table 1. Service Processor Checkpoints. (continued)
Checkpoint
Description
E070
Configuring modem
E072
Preparing to call home
E075
Service processor menus are available
E076
Leaving service processor menus;
attempting to disconnect modems
Action/ Possible Failing FRU
1. Try another modem configuration
from the service processor menus.
2. Check the cabling between the
modem and the system unit.
3. Replace the modem.
4. Replace the system board.
Location: P1
(See note 3 on page 115.)
1. Try another modem configuration
from the service processor menus.
2. Check the cabling between the
modem and the system unit.
3. Replace the modem.
4. Replace the system board.
Location: P1
(See note 3 on page 115.)
This code is posted on the operator
panel when the service processor
menus are available; the system is in
stand-by waiting for user input.
If the service processor menus are not
displayed on the ASCII terminal:
1. Verify that the ASCII terminal is
functional. Check the cable between
the ASCII terminal and the serial
port on the system.
2. Remove, then reapply AC power.
The service processor settings
(modem speeds and call-out
numbers, for example) may have to
be reentered.
3. Replace the system board.
Location: P1
(See note 3 on page 115.)
1. Try another modem configuration
from the service processor menus.
2. Check the cabling between the
modem and the system unit.
3. Replace the modem.
4. Replace the system board.
Location: P1
(See note 3 on page 115.)
Chapter 4. Checkpoints
89
Advertisement
Table of Contents
