IBM 6C1 Service Manual page 117
Pseries 610
Hide thumbs
Also See for 6C1:
- Technical overview and introduction (40 pages) ,
- Technical overview and introduction (42 pages) ,
- Installation manual (144 pages)
Table of Contents
Advertisement
Table 2. Firmware Checkpoints. (continued)
Checkpoint
Description
E172
First pass PCI device probe
E174
Establish host connection
E175
BootP request
E176
TFTP file transfer
Action/ Possible Failing FRU
1. If a location code is associated with
the checkpoint:
v Replace the FRU identified by the
location code
v Replace, one at a time, the other
PCI adapter cards on the same
PCI bus. See "Bus SRN to FRU
Reference Table" on page 178.
v Go to MAP 1540: Minimum
Configuration, "Step 1540-24" on
page 81.
2. If no location code is associated
with the checkpoint, go to MAP
1540: Minimum Configuration, "Step
1540-24" on page 81.
Refer to "Boot Problems/Concerns" on
page 110 for general considerations.
Refer to "Boot Problems/Concerns" on
page 110 for general considerations.
1. Turn off, then on, and retry the boot
operation.
2. Verify boot list by using the firmware
SMS Multiboot menus.
3. Verify the network connection
(network could be down).
4. Have network administrator verify
the server configuration for this
client.
Refer to "Boot Problems/Concerns" on
page 110 for general considerations.
1. Turn off, then on, and retry the boot
operation.
2. Verify boot list by using the firmware
SMS Multiboot menus.
3. Verify the network connection
(network could be down).
4. Have network administrator verify
the server configuration for this
client.
Chapter 4. Checkpoints
99
Advertisement
Table of Contents
