IBM 6C1 Service Manual page 143
Pseries 610
Hide thumbs
Also See for 6C1:
- Technical overview and introduction (40 pages) ,
- Technical overview and introduction (42 pages) ,
- Installation manual (144 pages)
Table of Contents
Advertisement
Table 3. Firmware Error Codes. (continued)
Error Code Description
25A80998 NVRAMRC script evaluation error -
command line execution error
25A80999 NVRAMRC script evaluation error - stack
unbalanced on completion
Action / Possible Failing FRU
Execution of a command line within
the NVRAM configuration variable
"NVRAMRC" (script) resulted in a
"throw" being executed. This script
can be modified by the system
firmware SMS utilities, the operating
system, PCI adapter ROM code or
utility, or an operator (through the
open firmware script editing command
nvedit). It may not be possible to
resolve the problem without a detailed
analysis of the NVRAM script, the
current system configuration, and
device tree contents.
1. The problem can be caused by a
SCSI controller/adapter, whose
SCSI bus ID has been changed
from the default setting, no longer
appearing in the system. This can
be caused either by removing a
SCSI controller/adapter, or a
problem with a SCSI
controller/adapter.
v Select the SCSI ID utility from
the SMS menus.
a. Verify the list of SCSI
controllers/adapters. If the
list is not correct, suspect a
problem with the
controller/adapter that is
installed but not listed.
b. Select the option to save
the configuration
information.
c. Restart the system.
v If the problem persists, boot the
operating system and verify the
SCSI bus IDs of any
installed/available SCSI
controllers/adapters (change as
necessary), and restart the
system.
2. Contact your service support
representative for further
assistance.
This is a firmware debug environment
error. There is no user action or FRU
replacement.
Chapter 5. Error Code to FRU Index
125
Advertisement
Table of Contents
