IBM 6C1 Service Manual page 178
Pseries 610
Hide thumbs
Also See for 6C1:
- Technical overview and introduction (40 pages) ,
- Technical overview and introduction (42 pages) ,
- Installation manual (144 pages)
Table of Contents
Advertisement
Table 3. Firmware Error Codes. (continued)
Error Code Description
450000D2 System bus protocol/transfer error
450000D3 I/O host bridge time-out error (checkstop) 1. Replace the FRU as indicated by
450000D4 I/O host bridge address/data bus parity
450000D6 System support function error (checkstop) 1. Replace the FRU as indicated by
450000D7 System bus internal hardware/switch
450000DA The processor was found deconfigured.
450000DB All memory DIMM pairs were found
45800000 Memory controller checkstop
160
Service Guide
(checkstop)
error (checkstop)
error (checkstop)
The service processor reconfigured the
available processor.
deconfigured. The service processor
reconfigured the best available pair.
Action / Possible Failing FRU
1. Replace the FRU as indicated by
the physical location code
displayed on the operator panel.
2. Check the service processor error
log for additional FRUs.
the physical location code
displayed on the operator panel.
2. Check the service processor error
log for additional FRUs.
1. Replace the FRU as indicated by
the physical location code
displayed on the operator panel.
2. Check the service processor error
log for additional FRUs.
the physical location code
displayed on the operator panel.
2. Check the service processor error
log for additional FRUs.
1. Replace the FRU as indicated by
the physical location code
displayed on the operator panel.
2. Check the service processor error
log for additional FRUs.
1. Note that this error code indicates
that the corresponding FRU has
been reconfigured. Check the
processor config/deconfig menu in
the service processor system
information menu before replacing
parts.
2. Replace the processor card.
Location: P1-C1
Location: P1-C2
1. Note that this error code indicates
that the corresponding FRU has
been reconfigured. Check the
processor config/deconfig menu in
the service processor system
information menu before replacing
parts.
2. Replace all memory DIMM pairs.
Go to "MAP 1540: Minimum
Configuration" on page 63.
Advertisement
Table of Contents
