IBM 6C1 Service Manual page 184
Pseries 610
Hide thumbs
Also See for 6C1:
- Technical overview and introduction (40 pages) ,
- Technical overview and introduction (42 pages) ,
- Installation manual (144 pages)
Table of Contents
Advertisement
Table 3. Firmware Error Codes. (continued)
Error Code Description
4B20000A The processor has been deconfigured.
4B200043 Service processor reports JTAG fail
4B200055 No processor found.
4B200056 No processor card.
4B200057 The processor cards are not compatible
4B200058 Compatibility test on processor card in
4B200059 Compatibility test on processor card in
166
Service Guide
with each other.
slot 1 failed.
slot 2 failed.
Action / Possible Failing FRU
1. Replace the processor card.
Location: P1-C1
Location: P1-C2
2. Replace the system board.
Location: P1
(See note 3 on page 115.)
1. Remove the processor card in slot
2 (P1-C2), if installed, and see if
the problem is resolved. If
resolved, replace the processor
card in P1-C2. If not, proceed to
step 2.
2. Exchange the processor card in
slot 1 (P1-C1) with the card
removed from slot 2 in step 1.
(Replace the card in slot 1 with a
new FRU if there is only one
processor card in the system.)
See if the problem is resolved. If
not, proceed to step 3.
3. Replace the system board.
Location: P1
(See note 3 on page 115.)
4. Call service support.
1. If only one processor is installed, it
must be in slot 1 (P1-C1).
2. If two processor cards are
installed, replace the card in slot 1
(P1-C1).
1. If only one processor is installed, it
must be in slot 1 (P1-C1).
2. If two processor cards are
installed, replace the card in slot 1
(P1-C1).
Remove the processor cards. Verify
that the FRU numbers are valid.
Replace if necessary.
Remove the processor cards. Verify
that the FRU numbers are valid.
Replace if necessary.
Remove the processor cards. Verify
that the FRU numbers are valid.
Replace if necessary.
Advertisement
Table of Contents
