IBM 6C1 Service Manual page 193
Pseries 610
Hide thumbs
Also See for 6C1:
- Technical overview and introduction (40 pages) ,
- Technical overview and introduction (42 pages) ,
- Installation manual (144 pages)
Table of Contents
Advertisement
Table 3. Firmware Error Codes. (continued)
Error Code Description
4BA80014 NVRAM (CRC) checksum fail.
4BA80015 NVRAM reintialization fail.
Action / Possible Failing FRU
This is a recoverable temporary
condition, unless followed by
4BA80015. If the system hangs at this
error code:
1. Remove, then reapply AC power.
The service processor settings
(modem speeds and call-out
numbers, for example) may have
to be reentered
2. Call service support.
1. Remove, then reapply AC power.
The service processor settings
(modem speeds and call-out
numbers, for example) may have
to be reentered
2. Replace the system board.
Location: P1
(See note 3 on page 115.)
The service processor settings
(modem speeds and call-out
numbers, for example) will have to
be reentered.
Chapter 5. Error Code to FRU Index
175
Advertisement
Table of Contents
