Placing The Model 6C1 In The Service Position - IBM 6C1 Service Manual
Pseries 610
Hide thumbs
Also See for 6C1:
- Technical overview and introduction (40 pages) ,
- Technical overview and introduction (42 pages) ,
- Installation manual (144 pages)
Table of Contents
Advertisement
Placing the Model 6C1 in the Service Position
Attention:
Care should be taken to ensure that a hazardous condition is not created
due to uneven mechanical loading when placing the system in the service position. If
the rack has a stabilizer, it must be firmly attached before placing the system in the
service position.
Before doing any actions inside the Model 6C1, you must put the system in the service
position. To place the system in the service position:
1. Release the left and right side latches
2. Pull the system toward the front until it is fully extended.
When the system is fully extended, safety latches on the slide rails lock into place. This
prevents the system from being accidentally pulled out too far and dropped.
1
After completing actions, return the system to the normal position by pressing in on the
safety latches (1).
255
Chapter 9. Removal and Replacement Procedures
Advertisement
Table of Contents
