Replacement - IBM 6C1 Service Manual
Pseries 610
Hide thumbs
Also See for 6C1:
- Technical overview and introduction (40 pages) ,
- Technical overview and introduction (42 pages) ,
- Installation manual (144 pages)
Table of Contents
Advertisement
8. Locate the battery on the system board.
Processor Card
Connectors
Memory Card
Connector
9. Pry the battery out of its mount using your fingernail. After the top of the battery has
cleared the plastic mount, pull it up and out of the system board.
Replacement
1. Ensure that the battery polarity is correct. (Plus (+) side away from plastic battery
mount.)
2. Using your thumb, gently press the battery into the battery mount. Use your index
finger to support the back of the battery mount during this operation.
3. Replace any removed processors or memory cards.
4. Replace the processor and memory card cover as described in "Processor and
Memory Card Cover" on page 264.
5. Replace the covers as described in "Covers" on page 258.
296
Service Guide
Plastic Battery Mount
Battery
Rear Battery Clip
Battery P/N
15F8409
Advertisement
Table of Contents
