Hot-Swap Fan Assembly; Removal - IBM 6C1 Service Manual
Pseries 610
Hide thumbs
Also See for 6C1:
- Technical overview and introduction (40 pages) ,
- Technical overview and introduction (42 pages) ,
- Installation manual (144 pages)
Table of Contents
Advertisement
Hot-Swap Fan Assembly
The following procedures cover removal and replacement of the hot-swap fan
assemblies.
Note: You do not need to turn off the power to the system to replace a hot-swap fan
The following illustration shows the replacement of a hot-swap fan assembly. Refer to
this illustration while performing the steps in this procedure.
1
2
3
1
3
5
7
9
11
Removal
1. If your system is a Model 6C1 (rack mount), place the system in the service position
as described in "Placing the Model 6C1 in the Service Position" on page 255.
assembly.
Hot-swap fan assembly 1
Fan 1 release button
Fan assembly 2 LED
Fan assembly 3 LED
Fan 3 release latch
Hot-swap fan assembly 4
4
5
12
10
11
2
Fan assembly 1 LED
4
Hot-swap fan assembly 2
6
Fan 2 release button
8
Hot-swap fan assembly 3
10
Fan assembly 4 LED
12
Fan 4 release latch
Chapter 9. Removal and Replacement Procedures
6
7
8
9
301
Advertisement
Table of Contents
