Component Leds; Resetting The Leds - IBM 6C1 Service Manual
Pseries 610
Hide thumbs
Also See for 6C1:
- Technical overview and introduction (40 pages) ,
- Technical overview and introduction (42 pages) ,
- Installation manual (144 pages)
Table of Contents
Advertisement
The following illustration shows the LEDs on the indicator panel, located inside the
server.
Component LEDs
In addition to the indicator panel or display, individual LEDs are located on or near the
failing components. The LEDs are either on the component itself or on the carrier of the
component (memory card, fan, memory module, CPU).
The LEDs are amber, except for the power supplies. For the power supplies, two green
LEDs (ac power good and dc power good) indicate the fault condition for the power
supply.
Resetting the LEDs
To reset the LEDs:
1. Replace the failing component with the new component.
2. Log in as root user.
3. At the command line, type diag.
4. Select Task Selection.
5. Select Log Repair Action.
6. Select the device that was repaired. (If the device is not listed, select sysplanar0.)
Fan
PCI
Memory
Fan
4
3
1
1
2
CPU
3
2
System Board
Power Board
Chapter 2. Diagnostic Overview
29
Advertisement
Table of Contents
