Related Manuals for Mackie SP400C
Summary of Contents for Mackie SP400C
-
Page 1: Instruction Manual
2-Way Ceiling Monitor Instruction Manual SP400C 100v FULL FULL RANGE RANGE HIGH (16 OHMS) PASS Sound Palette... -
Page 2: Table Of Contents
Mackie Designs strongly recommends that this equipment be installed only by a professional sound installer or contractor. -
Page 3: Introduction
The SP400C is ideal for use in business music systems and foreground/background music applications. Installing the SP400C is simple. The one-piece assembly includes the backcan, mounting tabs... -
Page 4: Installing The Sp400C
A. Installation with Plenum-Approved Jacketed Cable or Flexible Conduit Note: If you can access the back of the SP400C once it is mounted, you may prefer to do steps A3 and A4 before doing steps A1 and A2. - Page 5 (9) onto the rear cover and remove the strain relief assembly. B2.Open the terminal cover plate (7) on the back of the SP400C. Use a threaded conduit set-screw coupler (not supplied: For 1/2" conduit, use Thomas&Betts Steel City model TC221-SC or UL listed equivalent) and insert into the opening exposed by removing the strain relief assembly.
-
Page 6: Specifications
Operation in Low-Impedance Mode Frequency Response: 89 Hz–20 kHz SP400C – 6 4. Set the Tap Selector Switch (12). Make sure all the taps in the system add up to less than the rated power of the amplifier driving them. As a general rule, you should provide at least 10% headroom to account for insertion losses (i.e.,... - Page 7 Safety loop located at rear of enclosure for attachment of load bearing safety strap 6.6 in. (168 mm) 11.8 in. (300 mm) SP400C Frequency Response vs. Impedance SP400C Beamwidth vs. Frequency Vert BW Horz BW Safety Agency Rating UL1480: UL2043:...
-
Page 8: Service Information
For this reason, any current Mackie Design product may differ in some respect from its published description, but will always equal or exceed the original design specifications unless otherwise stated.