Sony SRW-5000 Maintenance Manual page 282
Hd digital
Hide thumbs
Also See for SRW-5000:
- Operation manual (202 pages) ,
- Installation manual (54 pages) ,
- Brochure & specs (12 pages)
Table of Contents
Advertisement
Removal
1. Removing the ME Wire
(1) Release the tip of the ME wire from the wire
holder.
(2) Remove the screw securing the lug terminal
of the ME wire.
(3) Grasp the hole of the wire cover with a pair
of pliers, press the claw on the cover in the
arrow direction, and remove the wire cover
from the plate holder (T) assembly.
(4) Remove the ME wire from the T drawer
assembly as shown in the figure.
2. Removing the T Drawer Assembly
(1) Disconnect the harness from the connector of
the tape top sensor.
(2) Release the harness from the hook of the T
drawer assembly.
(3) Remove the two screws.
(4) Remove the positioning boss (A) from the
positioning hole of the MD base assembly by
lifting up the T drawer assembly.
(5) Remove the positioning boss (B) from the
positioning hole (B) while turning the T
drawer assembly in the arrow C direction.
5-76
DT-47 board
Wire holder
T drawer assembly
Holes
Wire cover
Remove the ME Wire
Tape top sensor
PWH3 x 8
Harness
T drawer
assembly
Positioning
boss (B)
Positioning
hole (B)
Remove the T Drawer Assembly
PWH3 x 8
Lug terminal
Plate holder (T)
assembly
Claw
PWH3 x 8
Harness
Hook
Positioning boss (A)
Threading ring assembly
Positioning boss (A)
Positioning hole (A)
ME wire
C
SRW-5000/5500
Advertisement
Table of Contents
