Autopilot Computers - Simrad AP70 Installation Manual
Hide thumbs
Also See for AP70:
- Operator's manual (72 pages) ,
- Operation manual (66 pages) ,
- Quick start manual (6 pages)
Table of Contents
Advertisement
SD80
AD80
AC70
SI80
AC80A
AC80S
AC85
SG05
PRO
12 |
Rear - connectors
No.
Connector/Description
1
4 pin connector for 12/24 V DC local power, External alarm/Active unit OUT
2
Micro-C connector for CAN bus
3
Ethernet network port, used for sw update
Autopilot computers
The AP70/AP80 systems use a combination of 5 different enclosures and 4 boards to form a
flexible computer and interface system.
There are 7 standardized and 1 customized computers with built-in and optional boards as
shown below.
Refer "Computer boards" on page 74
SG05 PRO
The SG05 PRO Autopilot Computer provides autopilot control from AP70 and AP80 control
units to CAN bus/EVC steering systems.
The SG05 PRO receives sensor data (drive/rudder angle and boat speed) from the EVC, does
steering calculations and sends drive/rudder commands back to the EVC system which brings
drive/rudder to commanded angle.
Introduction |
AP70/AP80 Installation Manual
1
2
3
Hide quick links:
Advertisement
Table of Contents
