Mackie M-2600 Owner's Manual page 5
Fr series fast recovery high-current power amplifier
Hide thumbs
Also See for M-2600:
- Brochure (6 pages) ,
- Owner's manual (54 pages) ,
- Service manual (33 pages)
Table of Contents
Advertisement
7. In BRIDGED mode, connect an input cable
to CHANNEL 1's INPUT or CHANNEL 2. If
you want to use both inputs, the two input
signals are summed internally to produce a
mono signal.
8. In STEREO and MONO modes, connect
speaker cables to the SPEAKER OUTPUTS
, using either the binding post or
Speakon® connectors.
• The binding post connectors are wired
red = hot (+) and black = cold (–).
• See page 35 for Speakon wiring details.
9. In BRIDGED mode, connect the speaker
cable like this: the positive (+) wire goes in
the CHANNEL 1 SPEAKER OUTPUT's red
post and the negative (–) wire goes in
CHANNEL 2's red post. Plug nothing into
the black posts. There is also a single
Speakon connector for BRIDGED mode
(see page 35).
10. Connect the other ends of the speaker
cables to your loudspeakers.
11. Plug the amp's power cord
3-prong AC outlet properly configured for
the type of plug supplied with your amplifier,
and capable of delivering at least 20 amps
(for the 120V model). See page 29.
G
G
NEMA 5-20P
NEMA 5-20R
(Plug supplied with
(120 VAC, 20Amp
120 VAC models)
Receptacle)
12. Make sure your signal source (feeding the
M•2600's inputs) is powered up and
delivering signal to the amp.
13. Turn the M•2600's POWER
and verify that the SIG
showing an input signal is present.
120 VAC 60 Hz
2000 WATTS
14. Slowly turn both GAIN
You should hear the music and see the SIG
If the topmost LEDs (named OL, for
overload) are flashing, turn down either
the GAIN controls on the amp or the
source signal's output level controls (i.e.,
master faders). The point is: The OL LEDs
should not light up.
15. For quieter listening, it is preferable to
adjust the amp's GAIN
than the source signal's output level
(unless you have the source's control all
the way up!).
16. Start dancing, but don't let the ants out of
your pants.
Things You Must Remember:
into a
• Before making connections to an amp or
reconfiguring an amp's routing, turn the
amp's level (GAIN) controls down, turn
the power off, make the changes, turn
the power back on, and then turn the
level controls back up.
• If you shut down your equipment, turn
off the amplifiers first. When powering
up, turn on the amplifiers last.
• Save the shipping boxes! You may need
them someday, and you probably don't
switch on
want to have to pay for them again.
LEDs are
WARNING:
TO REDUCE THE RISK OF FIRE OR ELECTRIC SHOCK, DO NOT
EXPOSE THIS EQUIPMENT TO RAIN OR MOISTURE. DO NOT REMOVE COVER.
NO USER SERVICEABLE PARTS INSIDE. REFER SERVICING TO QUALIFIED PERSONNEL.
AVIS:
RISQUE DE CHOC ELECTRIQUE — NE PAS OUVRIR
1300 WATTS / CH
2600 WATTS
2 OHM LOAD MIN.
4 OHM LOAD MIN.
controls up:
and meter
LEDs flashing.
controls rather
• Never plug amplifier
outputs into anything
except speakers (unless
you have an outboard box
specifically designed to
handle high-power
speaker-level signals).
5
- Quick Links:
- Specifications M•2600
Hide quick links:
Advertisement
Table of Contents
