Embedded Sata Raid Controllers; Embedded Sata Raid Controller Requirements - Cisco UCS C220 M4 Installation And Service Manual
Hide thumbs
Also See for UCS C220 M4:
- Maintaining the server (72 pages) ,
- Quick start manual (29 pages) ,
- Service note (10 pages)
Table of Contents
Advertisement
Appendix C
RAID Controller Considerations
Embedded SATA RAID Controllers
VMware ESX/ESXi or any other virtualized environments are not supported for use with the embedded
Note
MegaRAID controller. Hypervisors such as Hyper-V, Xen, or KVM are also not supported for use with
the embedded MegaRAID controller.
This server includes an embedded MegaRAID controller that can control up to eight SATA-only drives.
This section contains the following topics:
•
•
•
•
•
•
•
•
Embedded SATA RAID Controller Requirements
The embedded SATA RAID controller hub requires the following items:
•
•
•
•
•
OL-32473-01
Embedded SATA RAID Controller Requirements, page C-11
Embedded SATA RAID: Two SATA Controllers, page C-12
Embedded SATA RAID Controller Considerations, page C-13
Installing a Software RAID 5 Key Module for Embedded RAID 5 Support, page C-13
Enabling the Embedded SATA RAID Controller in the BIOS, page C-13
Disabling the Embedded RAID Controller in the BIOS, page C-15
Launching the LSI Embedded RAID Configuration Utility, page C-15
Installing LSI MegaSR Drivers For Windows and Linux, page C-16
The embedded RAID option is available only with the small form factor drives version of this server
at this time.
Mini-SAS cables:
SFF 8-drive: UCS-220CBLSR8=
–
LFF 4-drive: UCS-220CBLSR4=
–
The embedded SATA RAID controller must be enabled in the server BIOS.
(Optional) A SATA RAID 5 key module.
This optional module can be installed to a motherboard header to add SATA RAID 5 support.
(Optional) LSI MegaSR drivers for Windows or Linux.
Cisco UCS C220 M4 Server Installation and Service Guide
Embedded SATA RAID Controllers
C-11
- Quick Links:
- Initial Server Setup
Hide quick links:
Advertisement
Table of Contents
