Cisco UCS C220 M4 Installation And Service Manual page 66
Hide thumbs
Also See for UCS C220 M4:
- Maintaining the server (72 pages) ,
- Quick start manual (29 pages) ,
- Service note (10 pages)
Table of Contents
Advertisement
Installing or Replacing Server Components
Install the RAID controller card into the new riser. Align the connector on the card with the socket
b.
on the riser and then carefully push it into the socket. Tighten the single thumbscrew that secures
the card to the riser bracket (see
Align the connector on the riser with the socket on the motherboard. At the same time, align the two
c.
slots on the back side of the bracket with the two pegs on the inner chassis wall.
Push down gently to engage the riser connector with the motherboard socket. The metal riser bracket
d.
must also engage the two pegs that secure it to the chassis wall.
Reconnect the SAS cable to its connector on the RAID controller card.
e.
Replace the top cover.
Step 4
Replace the server in the rack, replace cables, and then power on the server by pressing the Power button.
Step 5
Figure 3-17
1
Cisco modular RAID controller riser
assembly (top of bracket)
Cisco UCS C220 M4 Server Installation and Service Guide
3-28
Figure 3-18 on page
Cisco Modular RAID Controller Riser (Internal Riser 3) Location
FAN 6
FAN 5
FAN 4
FAN 3
FAN 2
FAN 1
Chapter 3
3-30).
PSU 2
SD 1
PSU 1
CPU 2
SD 2
PCIe Riser 2
PCIe Riser 1
CPU 1
1
2
Cisco modular RAID controller card in riser
Maintaining the Server
2
OL-32473-01
- Quick Links:
- Initial Server Setup
Hide quick links:
Advertisement
Table of Contents
