IBM 1200 Hardware Maintenance Manual page 47
Madge networks hub/switch user's manual
Hide thumbs
Also See for 1200:
- User manual (163 pages) ,
- Manual (162 pages) ,
- Maintenance manual (108 pages)
Table of Contents
Advertisement
2. Remove the battery pack.
3. Connect the AC Adapter.
4. Check that power is supplied when you power on the
computer.
5. Power off the computer.
6. Disconnect the AC Adapter and install the charged
battery pack.
7. Check that power is supplied by the battery pack when
you power on the computer.
If you suspect a power problem, refer the appropriate
power supply check listed below:
v "Checking the AC Adapter"
v "Checking operational charging" on page 38
v "Checking the Battery ASM" on page 38
Checking the AC Adapter
If the computer fails when only the AC Adapter is used, do
the following:
v If the power-on indicator does not turn on, check the
power cord of the AC Adapter for correct continuity and
installation.
v If the operational charge does not work, go to "Checking
operational charging" on page 38.
Unplug the AC Adapter cable from the computer and
measure the output voltage at the plug of the AC Adapter
cable. See the following figure:
Pin
1
2
If the voltage is not correct, replace the AC Adapter.
If the voltage is within the range, do the following:
v Replace the system board.
v If the problems still persist, go to "Undetermined
Problems" on page 47.
Voltage (V dc)
15.5 V. - 17.0 V.
Ground
ThinkPad i Series 1200/1300
37
- Quick Links:
- 1030 Memory Cover and Memory Card
Hide quick links:
Advertisement
Chapters
Table of Contents
