Table of Contents
Advertisement
3.
IDE connectors (40-1 pin PRI_IDE; 40-1 pin SEC_IDE)
The onboard IDE connectors are for Ultra DMA 133/100/66 signal cable(s).
There are three connectors on each Ultra DMA 133/100/66 signal cable:
blue, black, and gray. Connect the blue connector to the motherboard's IDE
connector, then select one of the following modes to configure your device(s).
Single device
Two devices
•
•
If any device jumper is set as "Cable-Select," make sure all other device
jumpers have the same setting.
M2NBP-VM CSM IDE connectors
1-26
Drive jumper setting
Cable-Select or
Master
Cable-Select
Master
Slave
Pin 20 on the IDE connector is removed to match the covered hole on the
Ultra DMA cable connector. This prevents incorrect insertion when you
connect the IDE cable.
Use the 80-conductor IDE cable for Ultra DMA 133/100/66 IDE devices.
M2NBP-VM CSM
®
Mode of device(s)
-
Master
Slave
Master
Slave
NOTE: Orient the red markings
(usually zigzag) on the IDE
ribbon cable to PIN 1.
PIN 1
Chapter 1: Product introduction
Cable connector
Black
Black
Gray
Black or gray
- Quick Links:
- Memory Configurations
Hide quick links:
Advertisement
Table of Contents
