Table of Contents
Advertisement
User Guide
3. Slide the power supply into the vacant slot until it locks.
To avoid damaging the power supply unit, do not tilt or twist the
unit as you push it into the connector.
4. Connect two power cords to the AC inlets. Use the standard power cord
coming with the server and the cord coming with the power supply.
The Power lamp (green) blinks when the power cords are connected.
If the lamp does not go on, check that power is supplied to the unit. If the lamp
remains off or the POWER FAIL lamp goes on amber, the power cord or the
power supply unit may be defective or the power supply bay containing the
power supply unit may be failed. Contact your service representative to ask for
maintenance.
5. Turn on the power of the server.
The power lamps on the power supplies go on.
6. Make sure that no error on the power supply are reported with the status lamp
and POST.
Caution
Figure 61: Installing a Power Supply Unit
A
Figure 62: Connecting the Power Cords
A: Power lamp
B: Power failure lamp
B
132
www.nec-computers.com
Advertisement
Table of Contents
