Epson TM-L90 Developer's Manual page 25
Hide thumbs
Also See for TM-L90:
- Technical reference manual (212 pages) ,
- Service manual (148 pages) ,
- User manual (112 pages)
Table of Contents
Advertisement
Confidential
After cutting, paper must be fed approximately 1 mm {16/406"} or more, then be stopped. Because, if it is
not, paper may be jammed in the autocutter unit. To prevent dot displacement after cutting, it is
recommended to feed paper for approximately 1 mm {16/406"} or more before printing.
Partial cut or full cut is not controlled by a software command.
If a die cut label is used, do not cut the label paper, because the label adhesive bonds to the autocutter blade,
causing a cutting problem. Cut the mounting paper between labels.
The manual cutter which is installed in the autocutter unit is assumed to cut the receipt (paper thickness:
approximately 75 mm) manually.
If the paper whose thickness is 100 mm or more is cut with the manual cutter, make sure to cut paper so
that the paper is not out of alignment.
The cutting type (partial cut or full cut) must be selected before the printer is first used. If the cutting type
is changed from partial cut to full cut after the printer has been used, the printer may not be reliable
because the wear-out level of the cutter blade differs.
1-14 Product Overview
Rev. A
Advertisement
Table of Contents
