Maintenance And Service; Working Instructions - Bosch GSG 300 Professional Original Operating Instructions
Hide thumbs
Also See for GSG 300 Professional:
- Original instructions manual (156 pages) ,
- Operational instructions (123 pages) ,
- Operating instructions manual (46 pages)
Table of Contents
Advertisement
OBJ_BUCH-75-002.book Page 9 Thursday, March 13, 2008 10:06 AM
Operation
Starting Operation
Observe correct mains voltage! The voltage
of the power source must agree with the
voltage specified on the type plate of the
power tool.
Switching On and Off
To start the power tool, press the On/Off switch
1 and keep it pressed.
To lock the pressed On/Off switch 1, slide the
On/Off switch 1 toward the rear.
To switch off the power tool, release the On/Off
switch 1, or when it is locked, briefly press the
On/Off switch 1 and then release it.
Working Instructions
Saw Blades and Saw Blade Guides
Depending on the material thickness to be
worked, various saw blade guides and the corre-
sponding saw blades can be used. See the Acces-
sories Overview for more details.
Base Plate
The foam rubber cutter can be used with or with-
out the base plate. The base plate is equipped
with rollers, and allows for easy and right-angled
guidance of the cutter.
For cutting random forms and for cutouts, it is
recommended to work without the base plate.
Cutting Foam
For precise cuts, especially with soft foams and
similar materials, work only with moderate feed.
To not press the material together or squeeze it
apart too excessively while working.
Dismount the base plate for smaller cutouts.
Puncture the material using a knife or a pair of
scissors, then insert the saw blade guide into the
opening und work the cutout.
For larger cutouts, select an entry opening large
enough to insert the saw blade guide with the
mounted base plate. Pay attention that no obsta-
cles are on the bottom of the material. Guide the
power tool with moderate pressure alongside the
cutout line.
Bosch Power Tools
Maintenance and Service
Maintenance and Cleaning
Before any work on the power tool itself,
pull the mains plug.
For safe and proper working, always keep
the power tool and the ventilation slots
clean.
The saw blade guide and the saw blades at regu-
lar intervals, approx. after 8 hours of operation.
Remove the saw blades from the power tool for
this and preferably clean the saw blades with
petrol. If required, use a scraper to clean the saw
blade guide. Apply a light coat of oil onto the saw
blade guide before assembling new or resharp-
ened saw blades.
If the power tool should fail despite the care tak-
en in manufacturing and testing procedures, re-
pair should be carried out by an after-sales ser-
vice center for Bosch power tools.
In all correspondence and spare parts orders,
please always include the 10-digit article number
given on the type plate of the power tool.
After-sales Service and Customer
Assistance
Our after-sales service responds to your ques-
tions concerning maintenance and repair of your
product as well as spare parts. Exploded views
and information on spare parts can also be found
under:
www.bosch-pt.com
Our customer consultants answer your questions
concerning best buy, application and adjustment
of products and accessories.
In case of a claim, repair or purchase of replace-
ment parts or in case of queries or other prob-
lems, please contact your local dealer or Bosch
representative.
English | 9
1 609 929 N76 | (13.3.08)
Advertisement
Table of Contents
