Cisco SPA232D Administration Manual page 140
Mobility enhanced phone adapter
Hide thumbs
Also See for SPA232D:
- Provisioning manual (213 pages) ,
- Quick start manual (17 pages) ,
- User manual (10 pages)
Table of Contents
Advertisement
Configuring the Voice Settings
PSTN (LINE Port)
Cisco SPA232D Administration Guide
VoIP Users and Passwords (HTTP Authentication)
Field
VoIP User 1/2/3/4/
5/6/7/8 Auth ID
VoIP User 1/2/3/4/
5/6/7/8 Password
VoIP User 1/2/3/4/
5/6/7/8 DP
PSTN-To-VoIP Gateway Setup
Field
PSTN-To-VoIP
Gateway Enable
PSTN Caller Auth
Method
Description
A user ID that a VoIP Caller can use for authentication by
using the HTTP Digest method (in other words, by
embedding an Authorization header in the SIP INVITE
message sent to the ATA. If the credentials are missing or
incorrect, the ATA will challenge the caller with a 401
response). The VoIP caller whose authentication user-id
equals to this ID is referred to VoIP User 1 of this ATA.
NOTE:
If the caller specifies an authentication user-id that
does not match any of the VoIP User Auth ID's, the INVITE
will be rejected with a 403 response.
Default setting: blank.
The password to be used with VoIP User 1. The user
assumes the identity of VoIP User 1 must therefore
compute the credentials using this password, or the
INVITE will be challenged with a 401 response
Default setting: blank.
For up to 8 VoIP users, specify the index of the dial plan to
be used after successful authentication. Dial plans are
configured in the
Dial Plans
disabled, the default dial plan is used for all unknown VoIP
users.
Default setting: 1.
Description
Select yes to enable or select no to disable PSTN-To-VoIP
Gateway functionality.
Default setting: yes
The method to authenticate a PSTN Caller to access the
VoIP gateway. Choose from none or PIN.
Default setting: none
section. If authentication is
4
139
- Quick Links:
- Connecting the Equipment
- Basic Setup
- Sip
Hide quick links:
Advertisement
Table of Contents
