Cisco SPA232D Administration Manual page 155
Mobility enhanced phone adapter
Hide thumbs
Also See for SPA232D:
- Provisioning manual (213 pages) ,
- Quick start manual (17 pages) ,
- User manual (10 pages)
Table of Contents
Advertisement
Configuring the Voice Settings
DECT Line 1 - DECT Line 10
DECT Line 1 - DECT Line 10
NOTE
Cisco SPA232D Administration Guide
PSTN Ring Thru Line 1 Ring Settings
Field
Default Ring
Use the Voice > DECT Line 1~DECT Line 10 pages to configure the settings for
calls using Cisco SPA302D handsets.
To open this page: Click Voice on the menu bar, and then click DECT Line 1~10 in
the navigation tree. Enter the settings as described below. After making changes,
click Submit to save your settings, or click Cancel to redisplay the page with the
saved settings.
When a DECT line receives an incoming from a RU and if no handset is registered
to this line or all handsets attached to this line are turned off, the base responds to
the RU in 9 seconds with "486 Busy Here."
General
Field
Line Enable
Description
The default ring to be used to ring through Line 1. Choose
from {1,2,3,4,5,6,7,8,Follow Line Cfg}. If Follow Line Cfg is
selected, the ring is determined by the distinctive ring
settings for Line 1. The ring patterns are configured on the
Voice > Regional page. For more information, see
Distinctive Ring Patterns, page
Default setting: 2
Description
To enable this line for service, select yes. Otherwise,
select no.
Default setting: yes
4
85.
154
- Quick Links:
- Connecting the Equipment
- Basic Setup
- Sip
Hide quick links:
Advertisement
Table of Contents
