Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Summary of Contents for Cable-Tronix CTA-30
- Page 1 INSTALLATION MANUAL CTA-30/1000 Wall Mount Distribution Amplifier...
-
Page 2: Package Contents
The unit is capable of CATV 2 to 139 and 95 to 99 channel operation from 54 MHz to 1000 MHz. The CTA-30/1000’s low-noise and low distortion specs allow it to be used in large networks requiring amplifier cascading. -
Page 3: Unpacking And Handling
Inspect the front and rear of the equipment for shipping damage. Make sure the equipment is clean, and no connectors are broken, damaged, or loose. If equipment appears to be damaged or defective please contact us at 1-610-429-1511 for assistance. 3. PRODUCT DIAGRAM MODEL CTA-30/1000 1000 Mhz Push-Pull Distribution Amplifier 54-1000 Mhz 30 dB GAIN... -
Page 4: Hardware Connections
For connection to a 120 VAC, 60Hz outlet 4. HARDWARE CONNECTIONS a. Mount the CTA-30/1000 securely onto a wall or equipment rack using screws or bolts through the mounting tabs. b. Connect a 75ohm coaxial cable with F-connectors from the RF source output to CTA- 30/1000’s Input port. -
Page 5: Troubleshooting
The CTA-30/1000’s Tilt Adjust control should be used to set the appropriate slope per system specifications. Note that the Tilt Adjust allows the adjustment of the gain-to-frequency characteristic of the amplifier. When making adjustments always apply the following principles: Input signal levels should ALWAYS exceed the noise figure of the amplifier by 3 to 6 The primary purpose of tilt (equalization) in a cable TV plant is to compensate for the slope generated in coaxial cable between the high and low TV frequencies.