System Board - IBM xSeries 200 Hardware Maintenance Manual
Hide thumbs
Also See for xSeries 200:
- Hardware maintenance manual (148 pages) ,
- Hardware maintenance manual (122 pages)
Table of Contents
Advertisement
Rubber
extensions
To remove the rear fan, do the following:
1. Power-off the server, if it is on.
2. Unplug the server.
3. Remove the cover (see "Removing the side cover" on
page 46).
4. Remove the support bracket (see "Removing the
support bracket assembly" on page 49).
5. Remove the fan cable from the system board.
6. Use side cutters to sever the four rubber extensions
on the outside of the server.
7. Gently pry the fan away from the server and lift it up
and out.
8. To install the new fan assembly, place the fan in
position at the rear of the server.
9. Guide the rubber extensions through the apertures.
10. Use needle-nosed pliers to pull the extensions
through the apertures.
11. Reconnect cables.
System board
Before you begin:
v Read "Safety information" on page 125.
v Review the information in "Before you begin" on page
44.
Note: It is recommended that the server be placed on its
left side before performing this service procedure.
Rotate the feet in toward the server so they do not
detach due to the weight of the server.
Chapter 6. FRU information (service only)
Rear
Fan
89
Advertisement
Table of Contents
Troubleshooting
