Table of Contents
Advertisement
DINION Housing Kit
6.
7.
8.
7.4
Closing the housing
Caution!
Always securely tighten all fittings to ensure a liquid-tight seal. Failure to do so could allow
!
water to enter the housing and damage the units. If a sealant is used, ensure that it is a
neutral cure type. Sealants that release acetic acid may harm electronics. Use drip loops on
the wiring outside the housing.
–
–
–
7.5
Positioning sunshield
1.
2.
3.
4.
Bosch Security Systems
Lock the back focus locking button.
Press and hold the center key for more than 1 second until all the menus disappear.
Close the side door panel.
Pull any excess wire out of the housing and tighten the cable glands. The tightening force
required is approximately 1 to 1.5 turns past the point where the gland starts to grip the
wire. Failure to correctly tighten the glands could result in water ingress.
Ensure that all holes are covered with the rubber plugs provided.
Close the cover and secure the latches. Optional tamper-resistant screws are provided
with the housing. If desired, secure the latch using these three screws and the provided
tamper-resistant wrench.
Close
Loosen the two screws (M4 x 10) on the top of the housing.
Slide the sunshield to the desired position. It has a range of 50 mm (2 in).
Tighten the screws to lock the sunshield into position.
If the sunshield is not installed, seal the two screw holes with the plugs supplied.
2x
Sunshield
3x
Installation Manual
Configuration and final assembly | en
2014.11 | 1.0 | F.01U.309.609
23
Advertisement
Table of Contents
