Installing A Dimm - HP ProLiant DL160 Gen9 User Manual
Hide thumbs
Also See for ProLiant DL160 Gen9:
- Maintenance and service manual (97 pages) ,
- User manual (135 pages) ,
- Maintenance and service manual (116 pages)
Table of Contents
Advertisement
•
DIMMs installed on channel 1 and channel 2 of an installed processor must be identical.
•
In multi-processor configurations, each processor must have a valid Mirrored Memory configuration.
•
In multi-processor configurations, each processor may have a different valid Mirrored Memory
configuration.
Installing a DIMM
Power down the server (on page 17).
1.
Remove all power:
2.
Disconnect each power cord from the power source.
a.
Disconnect each power cord from the server.
b.
Do one of the following:
3.
Extend the server from the rack (on page 17).
o
Remove the server from the rack (on page 20).
o
Remove the access panel (on page 21).
4.
Remove the expansion board.
5.
Open the DIMM slot latches.
6.
Install the DIMM.
7.
If removed, install the expansion board.
8.
Install the access panel (on page 22).
9.
Do one of the following:
10.
Slide the server into the rack.
o
Install the server into the rack
o
Power up the server (on page 17).
11.
To configure the memory mode, use HP UEFI System Utilities (on page 106).
("Expansion board
("Installing the server into the
options" on page 72)
rack" on page 30).
Hardware options installation 62
Advertisement
Table of Contents
