Indication Lamps; High-Beam Indication Lamp - Mitsubishi Lancer Owner's Manual
Hide thumbs
Also See for Lancer:
- Owner's manual (671 pages) ,
- Owner's manual (700 pages) ,
- Owner's handbook manual (16 pages)
Table of Contents
Advertisement
Instruments and controls
Indication lamps
Turn-signal indication lamps/
Hazard warning indication
lamps
These indication lamps blink in the fol-
lowing situations.
l
When the turn-signal lever is
moved to activate a turn-signal
lamp.
Refer to "Turn-signal lever" on
page 3-48.
l
When the hazard warning flasher
3
switch is pressed to activate the
hazard warning lamps.
Refer to "Hazard warning flasher
switch" on page 3-50.
l
When the hazard warning lamps
automatically activate due to sud-
den braking while driving.
Refer to "Emergency stop signal
system" on page 4-53.
NOTE
l
If these indication lamps blink too
fast due to any operation other
than sudden braking, the cause
may be a blown lamp bulb or a faul-
ty turn-signal connection.
High-beam indication lamp
This indication lamp illuminates when
the high-beam is used.
3-38
Front fog lamp indication
lamp*
E00501600100
This lamp illuminates while the front
fog lamps are on.
Rear fog lamp indication lamp
E00501700361
This lamp illuminates while the rear fog
lamp is on.
Position lamp indication lamp
This indication lamp illuminates while
the position lamps are on.
ECO mode indicator (for vehi-
cles equipped with A/T, CVT
or Twin clutch SST)
Except for vehicles for Russia, Kazakh-
stan and Ukraine, this indicator will be
displayed when fuel-efficient driving is
achieved.
Diesel preheat indication lamp
(diesel-powered vehicles)
This indication lamp illuminates when
the ignition switch is placed in the "ON"
position. As the glow plug becomes hot,
the lamp goes out and the engine can be
started.
E00501800160
OG1E12E1
NOTE
l
If the engine is cold, the diesel pre-
heat indication lamp is on for a lon-
E00501900363
ger time.
l
When the engine has not been star-
ted within about 5 seconds after
the diesel preheat indication lamp
went out, return the ignition
E00502000101
switch to the "LOCK" position.
Then, turn the switch to the "ON"
position to preheat the engine
again.
l
When the engine is warm, the die-
E00508900160
sel preheat indication lamp does
not come on even if the ignition
switch is placed in the "ON" posi-
tion.
E00529800087
E00502300263
Hide quick links:
Advertisement
Chapters
Table of Contents
